2001 Subaru Forester Engine Crankcase O Ring Parts

Showing 1 - 6 of 6 products
Image
SKU
Product
Rating
Price

Nippon Reinz
  • This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
  • Between Crankcase Halves - 19.2 x 2.4mm O-Ring
  • 19.2 x 2.4mm O-Ring (Between Crankcase Halves)

Additional Fitment Information:
Vehicle
2001 - Subaru Forester

Ishino Stone
  • This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
  • This is a rubber o-ring for the service hole cover (11093 AA000) on the Left rear of the crank case.
  • This is a rubber o-ring for the service hole cover (11093 AA000) on the rear of the crank case. This is also used as an AT o-ring for certain applications.

Additional Fitment Information:
Vehicle
2001 - Subaru Forester

Ishino Stone
  • This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
  • This is a rubber o-ring for the service hole cover (11093 AA000) on the left rear of the crankcase.
  • This is a rubber o-ring for the service hole cover (11093 AA000) on the rear of the crank case. This is also used as an AT o-ring for certain applications.

Additional Fitment Information:
Vehicle
2001 - Subaru Forester

Ishino Stone
  • This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
  • Aluminum washer for Plug on front and rear of Right Crankcase half and front of Left Crankcase half. (34mm OD.)
  • This is a aluminum washer to be used on the cylinder block plugs. 34mm OD.

Additional Fitment Information:
Vehicle
2001 - Subaru Forester

Ishino Stone
  • This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
  • This is a sealing washer for the Long Bolt that holds the Cylinder Block (Crankcase Halves) Together. Metal outer seal o-ring with a rubber seal inside. 19.5 mm OD
  • Crankcase bolt sealing washer.

Additional Fitment Information:
Vehicle
2001 - Subaru Forester

Ishino Stone
  • This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
  • Used between the crankcase halves at the lower second journal from the front - (OD is 39 mm)

Additional Fitment Information:
Vehicle
2001 - Subaru Forester
Showing 1 - 6 of 6 products

Loading...